Exact matches only
Search in title
Search in content
Search in posts
Search in pages
Filter by Categories

VD960 – ‘MagnaSensor’

Picture1

The VD960 is a stand alone digital Presence sensor. Magnas recognise vehicles by their ferrous content.  All parameters are self setting to suit site conditions. Mounted in the middle of the road below ground level, the direct burial cable, attached to the sensor goes directly to the control panel in a shallow slot.  The 4 wire cable is wired in and self-sets.

 

-  the Magna sensor, does not require any loops to be cut—the sensor does the job of the loops.

-  Saves time, mess and is much more reliable and quicker to install than a conventional loop detector.

-  Simpler wiring than a loop detector—just 4 wires to wire in and no module to fit - self setting,

-  It is a ‘presence’ sensor.

-  Digital technology allows exit sensors to to be over 100m from the control board.

Magna hi contrast thm

The VD960, known as the Magna sensor, is of a new generation of electronic sensors which do the job of a loop detector, except better and more reliably.  The Magna sensor recognizes vehicles by the ferrous content of the car. Unlike ordinary loop detectors, the sensor adjusts for most drainage and access covers.  .  It is a presence sensor that has a 2m diameter range.

With no loops needed, the installation takes a quarter of the time.  The VD960 only require 4 wires to be wired in and is self setting.  The Magna can also be fitted to a photo beam.  In new roads the Magna sensor can be passed down a pre-installed conduit.  It is transforming the loop detector industry.

{No Information Available}

{No Information Available}

VD962 Info Doc
VD962 Info Doc
VD960 Manual